MFC-CB v1.00b Embedded Software

Run Winflash and select the file downloaded as the file to write to the product.

Make sure the correct COM port of the product is connected to a RS232 port on the host PC. Use a null modem cable to COM2 port of PG7000 Piston Gauge. Use a standard RS232 cable to COM1 port of PPC, PPC, RPM and molbox.

The updating of embedded software should only be performed after given specific instructions to do so from a Fluke Calibration Authorized Service Center ».

If the update isn't performed properly, your product will be inoperable until it is.

Ver 1.00a (01 Oct 25)
FIX: "VSENSE" command would not accept a suffix.
CHG: Change the units displayed on the front panel to 'V' when the ''VOUT=" command is used, and to 'mA' when the "COUT=" command is used.

Ver 1.00 (01 Aug 14)
Inital release of software for new control box for MFCs and MFMs